HYBRID TX-MULTI COPY TRANSMITTER
MANUAL AND PROGRAMMING INSTRUCTIONS

New to the market the Hybrid transmitter is able to copy most existing installations, eliminating the need to use the corresponding remote when adding to an existing radio card. Easy to use and programme, its sleek and stylish design means it looks at home attached to anyone’s key ring. Also very strong and robust, being able to withstand being driven over by a car!

PROGRAMMING INSTRUCTIONS

ENTERING PROGRAMMING SEQUENCE
Firstly, press and hold the 1st and 2nd largest buttons until the LED begins to flash, and then release both buttons on the transmitter.

SELECTING WHICH BRAND TO PROGRAMME
Press the button on the transmitter you want to programme, keep the button pressed and observe the number of flashes. The transmitter will already be programmed into a system listed in the table below. Relate the number of flashes you observe and press the button until you obtain the number of flashes relating to the system you require to be programmed. Repeat for each button being programmed.

BFT RECEIVER – HIDDEN BUTTON
When programming into a BFT receiver, once you have selected the BFT brand as instructed above, press the 1st large button and 4th small button at the same time.

CLOSING THE PROGRAMMING SEQUENCE
Once you have selected your brand for a particular button, press and hold the 3rd and 4th smaller buttons simultaneously until the light begins to flash. At this moment release both buttons and programming is closed.

Programming must be closed after new brands have been programmed or existing brands modified.

The transmitter can be reset fully at any time by pressing the 3rd and 4th smaller buttons for more than 7 seconds.

Telephone: 0161 374 5655    Fax: 0161 374 5656

Please Click Here for the Remote Manual >